Braced door with the cedar cladding as the front material. This will be as seamless as possible into the shed area of the cladding
I am using 7 pieces of tongue and groove with the tongue off the end piece. A piece of 4X2 timber to but up against the frame and hold the hinges.
The process was stewing through the braces, 10mm into the cedar, then turning over and using the stainless ring shank nails on the from to hold.
I hadn't planned it, but this door is very heavy....
Pics below:
The front of the door, planned to loos seamless into the cladding if possible..
The back of the braced door. notches cut in, 6" screws to hold together. Screwed from the back, the nailed from the front.
Recessed door hinges:
Door Ftted:
No comments:
Post a Comment